DTC P0707:00 [DJVA-EL]
id0502l1817100
|
DTC P0707:00 |
TR switch multi-input |
|---|---|
|
DETECTION CONDITION
|
• Condition: TCM normal during engine rotation
• Status: Detects TR switch multiple input
• Period: Confirmed 5 times in 2 s or more
Diagnostic support note
• The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
• PENDING CODE is not available.
• The DTC is stored in the TCM memory.
|
|
POSSIBLE CAUSE
|
• TR switch malfunction
• TCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT TR SWITCH
• Inspect the TR switch.
• Is there any malfunction?
|
Yes
|
Replace the TR switch, then go to next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC using the M-MDS.
• Perform the following procedure to ensure that the DTC has been resolved:
• Is the same DTC present?
|
Yes
|
Perform the following procedure, then go to next step.
1. Replace the TCM.
2. Perform TCM learning.
(See TCM LEARNING [DJVA-EL].)
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY NO DTCs ARE PRESENT
• Perform the “Reading DTCs Procedure”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||