DTC P0883:00 [DJVA-EL]
id0502l1820100
|
DTC P0883:00 |
Battery voltage high |
|---|---|
|
DETECTION CONDITION
|
• Condition: TCM communication normal while engine is idling
• Status: Detects terminal B voltage of 18.00 V or higher
• Period: Confirmed 20 times continuously for 1 s or more
Diagnostic support note
• The AT warning light does not illuminate.
• PENDING CODE is not available.
• The DTC is stored in the TCM memory.
|
|
POSSIBLE CAUSE
|
• Generator malfunction
• TCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY DTC IS PRESENT
• Switch the ignition to ON (Engine off).
• Read the DTC in the PCM.
• Is the DTC P2504:00 output?
|
Yes
|
Perform the “DTC P2504:00 Troubleshooting”.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC using the M-MDS.
• Perform the following procedure to ensure that the DTC has been resolved:
• Is the same DTC present?
|
Yes
|
Perform the following procedure, then go to next step.
1. Replace the TCM.
2. Perform TCM learning.
(See TCM LEARNING [DJVA-EL].)
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY NO DTCs ARE PRESENT
• Perform the “Reading DTCs Procedure”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||