DTC U2100:00 [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]

id09021c399000

DESCRIPTION

Incomplete configuration
DETECTION CONDITION
•  Configuration was not completed.
POSSIBLE CAUSE
•  Keyless control module configuration error
•  Keyless control module malfunction

Diagnostic Procedure

Step

Inspection

Action
1
PERFORM KEYLESS CONTROL MODULE CONFIGURATION
•  Perform the keyless control module configuration using the M-MDS.
•  Operate the advanced key to activate the keyless control module.
•  Clear the DTC from the keyless control module using the M-MDS.
•  Operate the advanced key to activate the keyless control module.
•  Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Perform the keyless control module configuration again, then go to the next step.
(See KEYLESS CONTROL MODULE CONFIGURATION.)
No
Go to Step 3.
2
VERIFY TROUBLESHOOTING COMPLETED
•  Operate the advanced key to activate the keyless control module.
•  Clear the DTC from the keyless control module using the M-MDS.
•  Operate the advanced key to activate the keyless control module.
•  Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the keyless control module, then go to the next step.
(See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)
No
DTC troubleshooting completed.