OVERHEAD CONSOLE REMOVAL/INSTALLATION


id091700468800

1.  Shift to the D (ATX) or 4th gear (MTX) position. (4SD)

2.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.3 DISI Turbo].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].) (See BATTERY REMOVAL/INSTALLATION [MZ-CD 1.6].) (See BATTERY REMOVAL/INSTALLATION [MZR-CD 2.2].) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].) (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

3.  Remove the rain sensor cover. (Vehicles with auto light/wiper system) (See RAIN SENSOR REMOVAL/INSTALLATION)

4.  Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)

5.  Partially peel back the seaming welts.

6.  Remove the following parts:

(1)  Sunroof seaming welt (vehicles with sunroof)
(2)  Map light (See MAP LIGHT REMOVAL/INSTALLATION.)
(3)  Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)
(4)  Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

7.  Partially peel back the headliner fornt side. (See HEADLINER REMOVAL/INSTALLATION.)

8.  Detach the tabs A.

9.  Remove the tabs B and C.

10.  Pull the overhead console in the direction of arrow shown in the figure, then remove it.

Type A

am3zzw00013406

Type B

am3zzw00013407

11.  Install in the reverse order of removal.

Note
•  When install the overhead console, where the overhead console bracket is supported by hands.