1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque.
1. If any brake line has been disconnected during the procedures, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.
1. Tighten the brake pipe flare nut using the SST (49 0259 770B) or any commercially available flare nut wrench.
1. Disconnect the negative battery cable before performing any work that requires handling of connectors. (See BATTERY REMOVAL/INSTALLATION [ZY, Z6].) (See BATTERY REMOVAL/INSTALLATION [LF, L3].)
1. Make sure that there are no DTCs in the ABS/DSC memory after working on ABS/DSC related parts. If there are any DTCs in the memory, clear them.
1. When replacing or removing the following parts, perform the initialization procedure. (See COMBINED SENSOR INITIALIZATION PROCEDURE.) (See BRAKE FLUID PRESSURE SENSOR INITIALIZATION PROCEDURE.)
1. If any power steering fluid line has been disconnected, perform the following after installation of the power steering components. (See AIR BLEEDING.) (See POWER STEERING FLUID INSPECTION.)