DTC U2100:00 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2878800
|
DTC
|
U2100:00
|
Module configuration
|
|
|
DETECTION CONDITION
|
• Configuration write failure is detected
|
||
|
POSSIBLE CAUSE
|
• Module configuration procedure is not done properly.
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT WHETHER DSC HU/CM IS CONFIGURED
• Is DSC HU/CM configured?
|
Yes
|
Go to next step.
|
|
No
|
Configure DSC HU/CM using M-MDS.
(See DSC CONFIGURATION.)
|
||
|
2
|
VERIFY TROUBLESHOOTING COMPLETED
• Clear DTC from memory.
• Is same DTC present?
|
Yes
|
Replace DSC HU/CM, then go to next step.
|
|
No
|
Go to next step.
|
||
|
3
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||