INPUT/TURBINE SPEED SENSOR INSPECTION [FS5A-EL]

id051721801200

Caution

•  Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

On-Vehicle Inspection

1.  Perform the following procedures.

(1)  Disconnect the negative battery cable.

(2)  Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 1.8, MZR 2.0, MZR 2.5].) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.0 DISI].)

(3)  Disconnect the input/turbine speed sensor connector.

am6zzw00004867

2.  Measure the resistance between the input/turbine speed sensor terminals A and B.

am2zzw00001034

•  If there is any malfunction, replace the input/turbine speed sensor. (SeeINPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL].)

Off-Vehicle Inspection

1.  Measure the resistance between the input/turbine speed sensor terminals A and B.

am2zzw00001034

•  If there is any malfunction, replace the input/turbine speed sensor. (SeeINPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL].)