DTC U2100:00 [INSTRUMENT CLUSTER]

id0902e8999600

DESCRIPTION

•  Configuration error

•  Configuration has not been performed

DETECTION CONDITION

•  Configuration setting has not been performed.

POSSIBLE CAUSE

•  Instrument cluster configuration not implemented.

•  Instrument cluster malfunction

DESCRIPTION	• Configuration error • Configuration has not been performed
DETECTION CONDITION	• Configuration setting has not been performed.
POSSIBLE CAUSE	• Instrument cluster configuration not implemented. • Instrument cluster malfunction

Diagnostic Procedure

STEP	INSPECTION		ACTION
1	PERFORM INSTRUMENT CLUSTER CONFIGURATION • Perform the instrument cluster configuration using the M-MDS. (See INSTRUMENT CLUSTER CONFIGURATION.) • Clear the DTC from the instrument cluster using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER].) • Verify the instrument cluster DTC using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].) • Is the same DTC present?	Yes	Perform the instrument cluster configuration again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION.)
1		No	Go to Step 3.
2	VERIFY TROUBLESHOOTING COMPLETED • Clear the DTC from the instrument cluster using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER].) • Verify the instrument cluster DTC using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].) • Is the same DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE PRESENT • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER].)
3		No	DTC troubleshooting completed.