HEADLIGHT LEVELING SWITCH INSPECTION

id091800803700

1.  Remove the following parts:

(1)  Front scuff plate (driver-side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (driver-side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(4)  Decoration panel (driver-side) (See DECORATION PANEL REMOVAL/INSTALLATION.)

(5)  Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(6)  Lower panel (driver-side) (See LOWER PANEL REMOVAL/INSTALLATION.)

(7)  Headlight leveling switch (See HEADLIGHT LEVELING SWITCH REMOVAL/INSTALLATION.)

2.  Verify that the resistance and continuity between the headlight leveling switch terminals is as indicated in the table.

am6zzw00006356

•  If not as indicated in the table, or if the resistance is not within the specification, replace the headlight leveling switch.

am6zzw00006357

3.  Apply battery voltage to headlight leveling switch terminal E, and connect terminal A to ground.

4.  Verify that the LED illuminates.

•  If there is any malfunction, replace the headlight leveling switch.