PUSH BUTTON START REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
id0921008022z5
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Front scuff plate (Driver side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
- (2) Front side trim (Driver side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
- (3) Center panel upper (See CENTER PANEL UPPER REMOVAL/INSTALLATION.)
- (4) Decoration panel (Driver side) (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (5) Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)
- (6) Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
- (7) Meter hood (See METER HOOD REMOVAL/INSTALLATION.)
3. Release the tabs and remove the push button start from the meter hood.
4. Install in the reverse order of removal.
