RVM SWITCH INSPECTION

id092200163300

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Front scuff plate (Driver side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (Driver side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(4)  Decoration panel (Driver side) (See DECORATION PANEL REMOVAL/INSTALLATION.)

(5)  Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(6)  Lower panel (Driver side) (See LOWER PANEL REMOVAL/INSTALLATION.)

(7)  RVM switch (See RVM SWITCH REMOVAL/INSTALLATION.)

3.  Verify that the continuity between the RVM switch terminals is as indicated in the table.

am6zzw00005052

am6zzw00005053

•  If not as indicated in the table, replace the RVM switch.

am6zzw00004468

am6zzw00004469

4.  Apply battery positive voltage to RVM switch terminal E, and connect terminal A to ground.

5.  Verify that the LED illuminates.

•  If there is any malfunction, replace the RVM switch.