360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION

id152000010000

L.H.D.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

3.  Partially peel back the floor covering.

4.  Remove the foot support. (See FOOT SUPPORT REMOVAL/INSTALLATION.)

5.  While pressing the tabs in the directions of arrows (1) shown in the figure, pull the spacer in the direction of arrow (2) to detach the spacer tabs from the cover.

am6xuw00012290

6.  Remove the spacer.

7.  Remove the nuts.

am6xuw00012291

8.  Remove the cover.

9.  Disconnect the connector.

am6zzw00016337

10.  Remove the wiring harness clips.

11.  Remove the nuts.

am6zzw00016338

12.  Remove the 360° view monitor control module component.

13.  Remove the screws.

am6zzw00016339

14.  Remove the 360°view monitor control module from the bracket.

15.  Install in the reverse order of removal.

16.  Perform the 360° view monitor system aiming. (See 360°VIEW MONITOR SYSTEM AIMING.)

R.H.D.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

3.  Partially peel back the floor covering.

4.  Remove the foot support. (See FOOT SUPPORT REMOVAL/INSTALLATION.)

5.  While pressing the tabs in the directions of arrows (1) shown in the figure, pull the spacer in the direction of arrow (2) to detach the spacer tabs from the cover.

am6zzw00016340

6.  Remove the spacer.

7.  Remove the nuts.

am6zzw00016341

8.  Remove the cover.

9.  Disconnect the connector.

am6zzw00016342

10.  Remove the screws.

11.  Move the 360° view monitor control module in the direction of the arrow shown in the figure and remove it from the bracket.

am6zzw00016343

1.  Remove the nuts.

am6zzw00016344

2.  Remove the wiring harness clips.

3.  Remove the bracket.

12.  Install in the reverse order of removal.

13.  Perform the 360° view monitor system aiming. (See 360°VIEW MONITOR SYSTEM AIMING.)