NO.5 NO CREEP AT ALL (EXCEPT FOR GENERAL (L.H.D.) SPECS. SPORT AT) [FN4A-EL]


5	No creep at all
DESCRIPTION	• Vehicle does not move in D, S^1, L^1, M^*2 ranges, and R position when idling on flat paved road.
POSSIBLE CAUSE	• Either transaxle is stuck in 3GR or 4GR position, or clutch circuit slippage due to a stuck 3-4 clutch is stuck. 1. Clutch burned • Line pressure low • Shift solenoid D malfunction • Shift solenoid A malfunction • Shift solenoid B malfunction • Shift solenoid C malfunction • Pressure control solenoid malfunction • Body GND malfunction • Control valve body malfunction 2. Transaxle fixed in 3GR (Operation of fail-safe function) • Short or open circuit in wiring • Poor connection of connector • The electronic parts of output and input system is malfunction 3. The engine torque is not start • Torque converter is malfunction Note • Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.


STEP	INSPECTION		ACTION
1	• Does vehicle creep in any range/position?	Yes	Go to next step.
1	• Does vehicle creep in any range/position?	No	Inspect or adjust selector lever. (See SELECTOR LEVER REMOVAL/INSTALLATION.)
2	Check the value at the following PID using the WDS or equivalent. (See PCM INSPECTION [LF, L3].) • TP Is PID value okay?	Yes	Go to next step.
2		No	Repair or replace any defective parts.
3	Disconnect PCM. Is resistance between ground terminal at PCM connector and body ground less than 5.0 ohms?	Yes	Go to next step.
3		No	Repair open ground circuit.
4	Check LPS PID value. Is LPS PID value okay? (See PCM INSPECTION [LF, L3].)	Yes	Overhaul control valve body and repair or replace any defective parts. (See ATX workshop manual (FN4A-EL) [1623-10-98E].) If problem remains, overhaul transaxle and repair or replace any defective parts. (See ATX workshop manual (FN4A-EL) [1623-10-98E].)
4		No	Repair or replace any defective parts.
5	• Verify test results. - If okay, return to diagnostic index to service any additional symptoms. - If malfunction remains, inspect related Service informations and perform repair or diagnosis. - If vehicle not repaired, trouble shooting completed. - If vehicle not repaired or additional diagnostic information not available, replace PCM.