WASHER MOTOR INSPECTION

id091900805100

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Set the mudguard (RH) aside. (See MUDGUARD REMOVAL/INSTALLATION.)

3.  Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)

4.  Disconnect the washer motor connector from the washer motor.

5.  Disconnect the windshield washer hose from the washer motor.

6.  Disconnect the rear washer hose from the washer motor (WGN).

Warning

•  Water sprayed on the battery and ground could cause electrocution. When performing the washer motor inspection, prepare a container to collect washer fluid and be careful not to spray washer fluid.

7.  After connecting washer motor terminal A to the positive battery terminal, and terminal B to ground, verify that washer fluid sprays from the front side of the washer motor.

ac5wzw00002204

ac5uuw00000827

•  If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION.)

8.  After connecting washer motor terminal B to the positive battery terminal, and washer motor terminal A to ground, verify that washer fluid sprays from the rear side of the washer motor (WGN).

ac5wzw00002205

ac5uuw00000829

•  If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION.)