DTC P0219:00 [MZR-CD (RF Turbo)]
id0102f1148300
|
DTC P0219:00 |
Engine overspeed condition |
|---|---|
|
DETECTION CONDITION
|
• The PCM monitors the engine speed. If the engine speed is 6,000 rpm or more, the PCM determines that there is a malfunction in the control system.
Diagnostic support note
• The MIL does not illuminate.
• The DTC is stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• Inadequate engine compression due to engine internal malfunction
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to available Service Information.
• If vehicle is not repaired, go to Step 4.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT ENGINE COMPRESSION
• Inspect the engine compression.
• Is it normal?
|
Yes
|
Go to the next step.
|
|
No
|
Perform engine overhaul for repairs, then go to the next step.
|
||
|
4
|
VERIFY TROUBLESHOOTING OF P0219:00 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Start the engine.
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Is any DTC present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||