DTC U3000:4A [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2880300
|
DTC
|
U3000:4A
|
DSC unit mismatched installation
|
|
|
DETECTION CONDITION
|
• Detection of situation where vehicle-type or drive system input signal and DSC HU/CM information remains incongruent through CAN information
|
||
|
POSSIBLE CAUSE
|
• Mismatched installation of DSC HU/CM
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT DSC HU/CM FOR MISMATCHED INSTALLATION
• Verify DSC HU/CM part number
• Has a DSC HU/CM with the correct part number been installed?
|
Yes
|
Go to next step.
|
|
No
|
Replace with correct DSC HU/CM part number, then go to Step 4.
|
||
|
2
|
INSPECT RELATED WIRING HARNESS FOR MISMATCHED INSTALLATION
• Verify wiring harness part number
• Has a wiring harness with the correct part number been installed?
|
Yes
|
Go to next step.
|
|
No
|
Replace with correct DSC HU/CM part number, then go to next Step.
|
||
|
3
|
CONFIGURE DSC HU/CM
• Can DSC HU/CM configure properly?
|
Yes
|
Go to next step.
|
|
No
|
Replace DSC HU/CM
|
||
|
4
|
VERIFY TROUBLESHOOTING COMPLETED
• Make sure to reconnected all disconnect connectors.
• Clear DTC from memory.
• Is the same DTC present?
|
Yes
|
Replace DSC HU/CM, then go to next step.
|
|
No
|
Go to next step.
|
||
|
5
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||