DTC U0402:00 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2881800
|
DTC
|
U0402:00
|
Signal error from TCM
|
|
|
DETECTION CONDITION
|
• Correct data cannot be received from TCM
|
||
|
POSSIBLE CAUSE
|
• TCM malfunction
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT FOR TCM MALFUNCTION
• Switch the ignition to off.
• Using the M-MDS, perform the DTC inspection for the TCM.
• Are any DTCs detected?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE [FS5A-EL].)
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY THAT THE SAME DTC IS NOT PRESENT
• Clear the DTCs from the memory.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the TCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||