DTC P0883:00 [FS5A-EL]
id050221820100
|
DTC P0883:00 |
Battery voltage high |
|---|---|
|
DETECTION CONDITION
|
• Voltage of 16 V or more detected at TCM terminal 1M.
Diagnostic support note:
• This is a continuous monitor (CCM).
• The MIL illuminates if the TCM detects the above malfunction conditions during the first drive cycle.
• A PENDING CODE is not available.
• FREEZE FRAME DATA is available.
• The AT warning light illuminates.
• The DTC is stored in the TCM memory.
|
|
POSSIBLE CAUSE
|
• Generator malfunction
• TCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related Service information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY PCM DTC
• Switch the ignition to off, then to the ON.
• Verify the DTC in the TCM memory.
• Are DTC P2504:00 output?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [L8, LF, L5].)
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY TROUBLESHOOTING OF DTC P0883:00 COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC from the memory using the M-MDS.
• Start the engine and warm it up completely.
• Is the same DTC present?
|
Yes
|
Replace the TCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “After Repair Procedure”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [FS5A-EL].)
|
|
No
|
DTC troubleshooting completed.
|
||