OIL SEAL REPLACEMENT [FS5A-EL]

id051721804400

1.  Drain the ATF. (SeeAUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FS5A-EL].)

Caution

•  The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal.

2.  Remove the drive shaft and/or joint shaft. (SeeDRIVE SHAFT REMOVAL/INSTALLATION.) (SeeJOINT SHAFT REMOVAL/INSTALLATION.)

3.  Remove the oil seal using the screwdriver.

4.  Using the SST and a hammer, tap a new oil seal in evenly until the SST contacts the transaxle case.

am6zzw00002789

5.  Coat the lip of the oil seal with ATF.

6.  Install the drive shaft and/or joint shaft. (See DRIVE SHAFT REMOVAL/INSTALLATION.) (SeeJOINT SHAFT REMOVAL/INSTALLATION.)

7.  Add ATF. (SeeAUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FS5A-EL].)

8.  Perform the mechanical system test. (SeeMECHANICAL SYSTEM TEST [FS5A-EL].)