DTC P0560:16, P0560:17 [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]

id09021c405600

DETECTION CONDITION
P0560:16
A steering lock unit power supply circuit voltage of less than 9 V is detected for 10 s
P0560:17
A steering lock unit power supply circuit voltage higher than 16 V is detected for 0.5 s while the engine is running
POSSIBLE CAUSE
•  STEERING LOCK 10 A fuse malfunction
•  Battery malfunction
•  Connector or terminal malfunction
•  Short circuit to ground in wiring harness between battery and keyless control module connector terminal 1B
•  Open circuit in wiring harness between battery and keyless control module connector terminal 1B
•  Keyless control module malfunction

Diagnostic Procedure

Step

Inspection

Action
1
INSPECT STEERING LOCK 10A FUSE
•  Switch the ignition to off.
•  Disconnect the negative battery cable.
•  Remove the STEERING LOCK 10 A fuse.
•  Inspect the fuse.
•  Is the STEERING LOCK 10 A fuse normal?
Yes
Go to the next step.
No
Replace the STEERING LOCK 10 A fuse.
After replacement, go to Step 5.
2
INSPECT BATTERY
•  Measure the battery positive voltage.
•  Is the voltage 9—16 V?
Yes
Go to the next step.
No
Higher than specification
•  Recharge or replace the battery, then go to Step 5.
Lower than specification
•  Replace or charge the battery, then go to Step 5.
3
INSPECT KEYLESS CONTROL MODULE CONNECTOR CONDITION
•  Disconnect the keyless control module connector.
•  Inspect the connector and terminals(corrosion, damage, pin disconnection).
•  Is the connector normal?
Yes
Go to the next step.
No
Repair/replace the connector or terminal.
After repair procedure, go to Step 5.
4
INSPECT WIRING HARNESS BETWEEN BATTERY AND KEYLESS CONTROL MODULE
•  Inspect wiring harness between battery and keyless control module connector terminal 1B for the following:
―  Short to ground
―  Open circuit
•  Is the wiring harness normal?
Yes
Go to the next step.
No
Repair/replace the wiring harness.
After repair procedure, go to the next step.
5
VERIFY DTC
•  Install the STEERING LOCK 10 A fuse.
•  Reconnect the disconnected connectors and the negative battery cable.
•  Clear DTC using the M-MDS.
•  Verify DTC using the M-MDS.
•  Is the same DTC present?
Yes
Repeat the inspection from Step 1.
If the malfunction recurs, replace the keyless control module.
(See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)
Go to the next step.
No
Go to the next step.
6
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are there other DTCs output?
Yes
Perform the corresponding DTC inspection.
No
DTC troubleshooting completed.