DTC U0533:68 [INSTRUMENT CLUSTER]

id0902e8509900

DTC U0533:68

Signal error from rear vehicle monitoring control module (RH)

Detection Condition

Correct data cannot be received from rear vehicle monitoring control module (RH)

Possible Causes

Rear vehicle monitoring control module (RH) malfunction

DTC U0533:68	Signal error from rear vehicle monitoring control module (RH)
Detection Condition	Correct data cannot be received from rear vehicle monitoring control module (RH)
Possible Causes	Rear vehicle monitoring control module (RH) malfunction

Diagnostic Procedure

Step	Inspection		Action
1	INSPECT FOR REAR VEHICLE monitoring CONTROL MODULE MALFUNCTION • Switch the ignition to off. • Connect the M-MDS to the DLC-2. • Perform the rear vehicle monitoring control module DTC inspection using the M-MDS. (See DTC INSPECTION [REAR VEHICLE MONITORING SYSTEM].) • Is the DTC displayed again?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [REAR VEHICLE MONITORING SYSTEM].)
1		No	Go to the next step.
2	VERIFY THAT NO OTHER DTCs ARE RECORDED • Clear DTCs using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER].) • Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].) • Is DTC U0533:68 displayed?	Yes	Replace the rear vehicle monitoring control module (RH). (See REAR VEHICLE MONITORING CONTROL MODULE REMOVAL/INSTALLATION.)
2		No	DTC troubleshooting completed.