SUPPLIER IDENTIFICATION PROCEDURE [AUDIO]

id0902f6358400

Note

•  The supplier can vary with the unit. When asking the supplier (service center) for repair or replacement, identify the supplier and fill in the Audio Repair Order Form with the following procedures.

Identification Using the Label or Inscribed Lettering

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(2)  Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(3)  Shift knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

(4)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(5)  Center panel lower (See CENTER PANEL LOWER REMOVAL/INSTALLATION.)

(6)  Center panel upper (See CENTER PANEL UPPER REMOVAL/INSTALLATION.)

(7)  Climate control unit (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER].) (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER].)

(8)  Audio unit (See AUDIO UNIT REMOVAL/INSTALLATION.)

3.  Verify the supplier by referring to the label attached to each unit.

am6zzw00002502

Verify Using the Diagnostic Assist Function

1.  Switch the ignition to ACC or ON.

2.  Turn the audio unit power to on.

3.  While pressing the POWER/VOLUME switch, simultaneously press the Preset switch “5” for approx. 3 s or more.

With RDS (radio data system)

am6zzw00002503

Without RDS (radio data system)

am6zzw00003332

4.  Identify the supplier code by referring to the information display.

am6zzw00002504

Supplier code	Supplier name
01	SANYO Automedia
02	Panasonic
03	Clarion
04	Pioneer
05	VISTEON

Note

•  The supplier code can also be identified from the DTC displays screen.

am6zzw00002505

5.  Cancel the diagnostic assist function by either turning off the audio unit power or by ignition to the switched off.