DTC U0415:68 [REAR VEHICLE MONITORING SYSTEM]

id0902z2885500

Malfunction location

Detection condition

Possible Causes

Diagnostic Procedure

Step	Inspection		Action
1	INSPECT DSC FOR MALFUNCTION •  Switch the ignition to off (LOCK). •  Connect the M-MDS to the DLC-2. •  Perform the ABS or DSC DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].) •  Is the DTC displayed?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
		No	Go to the next step.
2	VERIFY CORRECTION COMPLETED •  Clear DTCs using the M-MDS. (See CLEARING DTC [REAR VEHICLE MONITORING SYSTEM].) •  Perform the rear vehicle monitoring control module DTC inspection again using the M-MDS. (See DTC INSPECTION [REAR VEHICLE MONITORING SYSTEM].) •  Is DTC U0415:68 displayed?	Yes	Replace the DSC HU/CM (See DSC HU/CM REMOVAL/INSTALLATION.)
		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE RECORDED •  Are any other DTCs displayed?	Yes	Perform the corresponding DTC inspection.
		No	DTC troubleshooting completed.