No.5 AUTO LEVELING DOES NOT ADJUST OPTICAL AXIS OF THE HEADLIGHTS FOR VEHICLE POSTURE [AFS (ADAPTABLE FRONT LIGHTING SYSTEM)]


id0903c6912500

5
Auto leveling does not adjust optical axis of headlights according to vehicle attitude
DESCRIPTION
•  Auto leveling does not adjust optical axis of headlights according to cargo and passenger weight conditions
POSSIBLE CAUSE
•  Headlight auto leveling actuator malfunction
•  AFS control module malfunction
•  Front auto leveling sensor malfunction
•  Rear auto leveling sensor malfunction
•  Front auto leveling sensor is not installed properly
•  Rear auto leveling sensor is not installed properly
•  Vehicle speed signal related part malfunction

Diagnostic Procedure

Step

Inspection

Action

1
INSPECT HEADLIGHT AUTO LEVELING WARNING LIGHT ILLUMINATION
•  Switch the ignition to ON.
•  Inspect the headlight auto leveling warning indicator light condition.
•  Does the headlight auto leveling warning illuminate 3 s after switching the ignition to ON?
Yes
Go to symptom “No.4 Auto leveling warning light illuminates when the ignition is switched to ON” troubleshooting procedure.
No
Go to the next step.
2
INSPECT IF MALFUNCTION IS IN AUTO LEVELING SENSOR OR ELSEWHERE
•  Switch the ignition to off.
•  Switch the ignition to ON.
•  Turn the headlights on at low beam.
•  Jump DLC-2 terminal B to ground using a jumper wire.
•  Inspect the headlight optical axis movement.
•  Does the optical axis move up and down on both sides?
Yes
Go to the next step.
No
Go to Step 5.
3
INSPECT IF MALFUNCTION IS IN WIRING HARNESS BETWEEN HEADLIGHT AUTO LEVELING ACTUATOR AND AFS CONTROL MODULE OR ELSEWHERE
•  Inspect for an open or short circuit in the wiring harness on the side where the auto leveling function does not operate.
RH:
―  AFS control module terminal J—front combination light (RH) terminal (6-pin) C
―  AFS control module terminal I—front combination light (RH) terminal (6-pin) E
―  AFS control module terminal L—front combination light (RH) terminal (6-pin) F
LH:
―  AFS control module terminal J—front combination light (LH) terminal (6-pin) C
―  AFS control module terminal K—front combination light (LH) terminal (6-pin) E
―  AFS control module terminal L—front combination light (LH) terminal (6-pin) F
•  Is an open or short circuit detected?
Yes
Repair or replace the malfunctioning part for an open or short circuit.
No
Go to the next step.
4
INSPECT IF MALFUNCTION IS IN HEADLIGHT AUTO LEVELING ACTUATOR OR ELSEWHERE
•  Replace the front combination light on the suspected side.
•  Perform Step 2 inspection procedure again.
•  Does the optical axis move up and down?
Yes
Troubleshooting is completed.
(The malfunction is in headlight leveling actuator.)
No
Replace the AFS control module.
5
INSPECT IF MALFUNCTION IS IN WIRING HARNESS BETWEEN AFS CONTROL MODULE AND HEADLIGHT AUTO LEVELING ACTUATOR
•  Inspect for an open or short circuit in the wiring harness on the side where the auto leveling function does not operate.
RH:
―  AFS control module terminal J—front combination light (RH) terminal (6-pin) C
―  AFS control module terminal L—front combination light (RH) terminal (6-pin) F
LH:
―  AFS control module terminal J—front combination light (LH) terminal (6-pin) C
―  AFS control module terminal L—front combination light (LH) terminal (6-pin) F
•  Is an open or short circuit detected?
Yes
Repair or replace for an open or short to the ground circuit.
No
Go to the next step.
6
INSPECT FRONT AND REAR AUTO LEVELING SENSOR INSTALLATION
•  Inspect the front and rear auto leveling sensor installation (bent or damaged bracket, or dislocated link).
•  Are the front and rear auto leveling sensors installed properly?
Yes
Go to the next step.
No
Repair or replace the malfunctioning part, then install the auto leveling sensor properly.
7
INSPECT FRONT AUTO LEVELING SENSOR
•  Inspect the front auto leveling sensor.
•  Is the front auto leveling sensor normal?
Yes
Go to the next step.
No
Replace the front auto leveling sensor.
8
INSPECT REAR AUTO LEVELING SENSOR
•  Inspect the rear auto leveling sensor.
•  Is the rear auto leveling sensor normal?
Yes
Go to the next step.
No
Replace the rear auto leveling sensor.
9
INSPECT IF MALFUNCTION IS VEHICLE SPEED SIGNAL OR AFS CONTROL MODULE
•  Inspect the speedometer using the speedometer tester.
•  Does the speedometer indicate vehicle speed properly?
Yes
Replace the AFS control module.
No
Perform the instrument cluster troubleshooting “No.7 Speedometer indication is defective” procedure.