FRONT SHOCK ABSORBER AND COIL SPRING REMOVAL/INSTALLATION

id021300801400

Caution

•  Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled while servicing the vehicle.

1.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [13B-MSP].)

2.  Remove the front suspension tower bar. (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION [MT].) (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION [AT].)

3.  Remove in the order indicated in the table.

4.  Install in the reverse order of removal.

5.  Inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.)

ar8wzw00001537

1	Brake hose bracket
2	Front stabilizer control link
3	Front upper arm ball joint (See FRONT UPPER ARM REMOVAL/INSTALLATION.)
4	Front shock absorber and coil spring, front upper arm
5	Front shock absorber and coil spring