INTRUDER SENSOR REMOVAL/INSTALLATION

id091400809400

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Roof side trim (See ROOF SIDE TRIM REMOVAL/INSTALLATION.)

(2)  Sunroof seaming welt (vehicles with sunroof)

(3)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(4)  Rear seat (See REAR SEAT REMOVAL/INSTALLATION.)

(5)  Inner scuff plate (See INNER SCUFF PLATE REMOVAL/INSTALLATION.)

(6)  Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(7)  Rear pillar trim (See REAR PILLAR TRIM REMOVAL/INSTALLATION.)

(8)  Map light (See MAP LIGHT REMOVAL/INSTALLATION.)

(9)  Interior light (See INTERIOR LIGHT REMOVAL/INSTALLATION.)

(10)  Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)

(11)  Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

3.  Disconnect the keyless control module connector.

4.  Remove the bolts.

ar8wzw00000083

5.  Remove the intruder sensor.

6.  Install in the reverse order of removal.