NO.2 VEHICLE MOVES IN N POSITION[GF4AX-EL]

id0503a3800700

2

Vehicle moves in N position

DESCRIPTION

•  Vehicle creeps if brake pedal is not depressed in N position.

POSSIBLE CAUSE

•  If the vehicle moves in N position, the malfunction is in the ATX. A malfunction in the sensor circuit or output circuit may cause of the ATX malfunction. Inspect the sensors, output circuit, and related wiring harnesses.

1.  Clutch burnt (Forward clutch)

•  Line pressure low

•  Control valve body malfunction

2.  Selector lever position disparity (Although the selector indicator shows N position, hydraulic circuit shows D range or R position)

Note

•  Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.

Diagnostic procedure

STEP	INSPECTION		ACTION
1	Does the vehicle creep when the selector lever is moved slightly in N position?	Yes	Replace the control valve body. (See ATX Workshop Manual (GF4AX-EL)) If any problem remains, replace the transaxle and repair or replace any malfunctioning parts. (See AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/INSTALLATION[GF4AX-EL].)
1		No	Inspect and adjust the selector lever. (See SELECTOR LEVER INSPECTION.) (See SELECTOR CABLE ADJUSTMENT.)
2	• Verify the test results. ― If normal, return to the diagnostic index to service any additional symptoms. ― If the malfunction remains, inspect the related Service Information and perform repair or diagnosis. • If the vehicle is repaired, troubleshooting is completed. • If the vehicle is not repaired or additional diagnostic information is not available, replace the PCM.