BODY ALIGNMENT INSPECTION

id091000802100

Caution

•  Do not attempt to correct any serious misalignment with one pulling/pushing operation. Damage to the structure could occur.

•   In case of severe or sharp bends, it may be necessary to use heat. Any attempt to cold-straighten a severely bent bracket may cause ruptures of the welds. It may also cause cracks in the bent part. Never heat the area to more than 650°C (1,200°F). Always use temperature-indicating crayons when applying heat to any part.

Note

•  All measurements should be made from the bare metal. Remove trim and bumper covers as necessary.

1.  Repair the badly damaged areas before measuring for underbody alignment.

2.  To check the underbody alignment, measure between opposite reference points, such as crease lines or weld joints.

3.  Observe the upper body structure for excessive stress or movement while making any corrections to the underbody structure. Remove all the necessary glass to prevent breakage. (See WINDSHIELD REMOVAL.)(See WINDSHIELD INSTALLATION.)(See QUARTER WINDOW GLASS REMOVAL.)(See QUARTER WINDOW GLASS INSTALLATION.)