DTC B2477 [L3]


DTC	B2477		ABS HU/CM configuration system
DETECTION CONDITION		• Programmed vehicle data does not correspond with vehicle data stored in the ABS CM.
POSSIBLE CAUSE		• Module configuration procedure was not completed properly


STEP	INSPECTION		ACTION
1	VERIFY CONFIGURATION • Has the ABS HU/CM configuration been performed?	Yes	Go to the next step.
1		No	Perform configuration using the WDS or equivalent.
2	VERIFY THAT THE SAME DTC IS NOT PRESENT • Clear the DTC from the memory. (See Clearing DTCs Procedures.) • Is the same DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the ABS HU/CM. (See ABS HU REMOVAL/INSTALLATION.)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE PRESENT • Are any other DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC Table.)
3		No	DTC inspection completed.