Control Module Box, Remove/Install

Removing And Installing Control Module Box

Illustrated On Model 202:

1 Disconnect ground lead from battery
2 Unscrew screws (1a) and remove cover (2)

NOTE: Installation: Ensure that cover gasket is in good condition and properly seated

3 Remove control module blower (M2/2) upward
4 Remove control modules from control module box (F23/1)

NOTE: CFI control module (N3), traction system control module (N47), relay module (K40)

5 Loosen screw (6)

NOTE: Installation: Install holder with screw (6) before installing screws (1b) in control module box


6 Unscrew screws (4) for data link connector (X11/4)
7 Unscrew screws (1b) and remove top section of control module box (F23/1)

NOTE: Release connector outside of control module box by turning control module box to right


8 Remove cover below instrument panel (passenger side)
9 Carefully pull connection leads for control modules out into passenger footwell or component compartment


NOTE: While disconnecting lead passages to component compartment in control module box. Disconnect leads which are not separable, e.g. electronic transmission control (ETC) at foot plate in passenger footwell


10 Remove nuts (3) and remove bottom section of control module box (F23/1) from component compartment


NOTE: Installation: Ensure that gasket for control module box (F23/1) is in good condition and is seated properly


11 Reinstall in opposite order