AZ82.60-P-0001-01VC Retrofit iPod Interface Wiring Harness

AZ82.60-P-0001-01VC Retrofit iPod Interface Wiring Harness
- with CODE (527) COMAND APS with single DVD drive (with navigation)
- with CODE (512) COMAND APS with DVD changer

Component Identification:

1 Make a mark on outside of glove box (14) as illustrated and drill hole with a diameter of 20 mm. Cordless drill/driver

Cordless drill/driver
gotis://G_58.0_01.1

Dimensions:
A = 15 mm
B = 15 mm

2 Open glove box lid and lead iPod wiring harness (9) to the outside through previously drilled hole.
3 Plug hole with grommet (13) on iPod wiring harness (9).
4 Fix iPod wiring harness (9) in place on glove box (14) using cable tie (arrow).

The black iPod wiring harness coupling and the white 2-pin coupling are not connected until the iPod interface is installed.

5 Set down glove box (14) in front passenger footwell.
6 Route iPod wiring harness (9) in installation opening of COMAND operating, display and controller unit

Component Identification:

7 Remove fiber optic cable coupling (15) from black, 40-pin coupling (3) and install at same position in black 40-pin coupling (5).

Only if fiber optic cable coupling (15) is installed.

8 Assemble black 40-pin coupling (3) and black 40-pin connector, lock in place, and stow below in installation opening of COMAND operating, display and controller unit.

The black 18-pin coupling and the white 2-pin connector will not be connected until the iPod interface is installed.