AZ82.60-P-0001-02VA Retrofit iPod Wiring Harness

AZ82.60-P-0001-02VA Retrofit iPod Wiring Harness
- with CODE (527) COMAND APS (with navigation)

1 Drill a hole (23) in the center console (13) as per the dimensions.

Component Identification:

2 Slide coupling for interface (5) of iPod wiring harness (1) from the inside out of center console (13) through drilled hole (see arrow).

3 Close hole with grommet (6) of iPod wiring harness (1).

The iPod coupling (2) of the iPod wiring harness (1) will be connected to the iPod at a later point in time.

4 Unscrew nut (25).
5 Place center console (13) onto center tunnel.
6 Lift up front center console (26) until the coupling for interface (5) can be pushed through between the center tunnel and the front center console (26).
7 Fasten center console (13) on center tunnel.

Do not pinch and damage retrofitted iPod wiring harness (1) with the center console (13).

8 Route iPod wiring harness (1) as per the picture between the front center console (26) and the shift block (27), and secure in place using cable tie.

The interface connector (5) can be connected to the iPod interface later.

Illustrated with removed rear center console