AN82.61-P-0001-01VA Retrofit Wiring Harness

AN82.61-P-0001-01VA Retrofit Wiring Harness
- with CODE (523) Radio MB Audio 20
- with CODE (533) Front and rear speakers -without radio-

Component Identification:

1 Route breaker point bracket (2) with red line (rt) through recess clearance (see arrow) for gray fuse carrier (1) of interior fuse box (F34) into the interior.
2 Insert gray fuse carrier (1) into socket 26 of interior fuse box (F34) and assign with a 30A fuse.

Gray fuse carrier (1) should catch audibly.

3 Route red line (rt) from interior fuse box (F34) along existing lines into cable duct (4) behind instrument cluster and attach with tie straps.
4 Continue routing red line (rt) in cable duct (4) into radio recess.
5 Attach red line (rt) together with antenna line (5) of the GPS antenna (A2/23) to existing lines in the cable duct (4).

6 Route red line (rt) along existing lines behind restraint systems control unit (N2/7) into the right footwell and attach with tie straps.

7 Route red line (rt) on center tunnel and along existing lines in the right footwell.

The breaker point bracket (2) of the red line (rt) will be installed into a black, 4-pin connector and then connected to the audio gateway control unit at a later point in time.
The red line (rt) will be attached later together with the other retrofitted wiring harnesses to the existing wiring harness using tie straps.