AR01.10-P-0110-01V Crank Engine With Starter
AR01.10-P-0110-01V Crank Engine With Starter
001 589 76 21 00
Compression recorder
220 589 00 99 00
Electrical connection set
Ensure that the ignition is switched off and the key has been removed from the ignition switch (electronic ignition switch control unit).
1 Remove cover (1) of the fuse and relay box (F1).
Installation: Check sealing rubber in the cover (1) and replace as necessary. The cover (1) must be located in the groove at the rear.
2 Pull out starter relay (N10/1clutch control) from relay location S.
3 Plug adapter cable (2) into plug position 3 of the starter relay (N10/1clutch control).
4 Link adapter line (2) to the cable of the compression recorder (7).
5 Open cover (3) of front backup fuse box (F32).
6 Connect connection terminal (4) of compression tester (7) to terminal (5) of the front prefuse box (F32).
7 Crank engine so that the contact switch (6) on the compression tester (7) is actuated.