AR35.30-P-0661-02P Joint Hub on Rear Axle Shaft - Pressing Off, Pressing on and Staking
AR35.30-P-0661-02P Joint hub on rear axle shaft - Pressing off, pressing on and staking
- with rear axle set
Staking tool for securing joint hub on rear halfshaft
Half shells (2 pieces) for pressing off or for caulking the inner constant velocity joint
Special Tools:
Press off joint hub
Component Identification:
1 Press joint hub (37d) off rear axle shaft using drift.
2 Check joint hub (37d) and rear axle shaft (37a) for damage on spline edges.
If on the splined profile of the joint hub (arrow) not more than 3 teeth per caulking, up to a maximum length of 6 mm, have broken out, the joint hub (37d) can continue to be used.
Press on joint hub
Component Identification:
3 Clamp rear axle shaft in vise (use protective jaws).
4 Using a suitable tool press on joint hub (37d) until dimension (b) is reached.
Caulk joint hub
Component Identification:
5 Clamp rear axle shaft in the vise so the joint hub (37d) lies on the jaws.
It must still be possible to turn the ball retainer.
6 Apply the new caulkings to be applied (arrows) with caulker centrally between the existing caulkings.
Component Identification:
In order to prevent damage (e.g. breaking away) of the ball raceways, the caulkings must be applied as close as possible to the splined profile.