Electronic Selector Lever Codes

Version 203 Electronic Selector Lever Codes

DTC Test scope

EP1860 The right rear wheel rpm signal sent from the traction system via the CAN bus is implausible.�

EP1861 The left rear wheel rpm signal sent from the traction system via the CAN bus is implausible.�

EP1876 The signals sent by control unit N47-5 (ESP and BAS control module) for the wheel speeds and the braking torque are not available on the CAN bus.�

EP2000 The braking torque value sent from the traction system via the CAN bus is implausible.�

EP2001 The signal sent by control unit N73 (EIS [EZS] control unit) for the stop lamp status is not available on the CAN bus.�

EP2010 The braking signal sent from the traction system via the CAN bus is implausible.�

EP2012 The brake signal from control unit N47-5 (ESP and BAS control module) is not available on the CAN bus.�

P1750 The supply voltage of the control unit is too low (undervoltage).�

P1832 The output stage in control module N15/5 (Electronic selector lever module control unit) has Short circuit.�

P1833 The output stage in control module N15/5 (Electronic selector lever module control unit) has Open circuit.�

P1856 Selector lever position detection has failed.�

P1875 CAN communication with other control units installed in this vehicle is not possible.�

P1910 The supply voltage of the control unit is too high (overvoltage).�

P2002 The tip switch in the floor-mounted shift has a short circuit to ground.�

P2003 The tip switch in the floor-mounted shift has an open circuit.�

P2004 The tip switch in the floor-mounted shift has a short circuit to positive.�

P2005 The voltage value of the touch pushbutton is implausible.�

P2006 The voltage value of the touch pushbutton is implausible.�

P2007 Control unit N15/5 (Electronic selector lever module control unit) is defective.�

P2008 Control unit N15/5 (Electronic selector lever module control unit) is defective.�

P2009 Control unit N15/5 (Electronic selector lever module control unit) is defective.