Manufacturer Code Charts: 1425

Wheel speed signal is implausible.


Possible cause:

- The signal transmitted by the CAN databus for the wheel speeds is implausible.
Affected functions:

- Electronic stability program ESP

-------------------------------------------------

Test 1: Test wheel speed signals.

1. Test wheel speed signals.
The actual values are supplied through CAN bus from component N47-5 (ESP, SPS [PML] and BAS control unit).Test prerequisites

- CAN communication to control module N47-5 (ESP, SPS [PML] and BAS control unit) is o.k.
Test sequence

- Switch on ignition.
- Rotate relevant wheel.(n >60 1/min)
Status of the relevant actual values:
- Vehicle speed at rear axle:Warning! Communication with ECU required.
- Vehicle speed at front axle:Warning! Communication with ECU required.
Specified values

- Vehicle speed>3 km/h
Question

- Are the actual values o.k.?


YES
The actual values are okay.End of test

NO
The actual values are not okay.Possible cause and remedy

- Read fault memory from control unit ESP and rectify faults.
End of test