High Speed Test

1. Turn ignition switch to ON.
2. Turn wiper switch to HI.
3. Check voltage at motor connector terminal 56. If voltage is present, proceed to step 5.
4. If voltage is not present proceed as follows:
a. Check voltage at wiper switch terminal 63. If voltage is present, replace wiper switch.
b. If voltage is not present at terminal 63, check circuit back to source.
5. If voltage is present at terminal 56 and motor will not run, proceed as follows:
a. Ground motor to body.
b. If motor runs, repair ground.
c. If motor does not run, replace motor.