Operation CHARM: Car repair manuals for everyone.
Home >> Mercury >> 1995 >> Mystique V6-153 2.5L DOHC >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Throttle Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Throttle Position Sensor: Service and Repair

Throttle Position Sensor:






REMOVAL

1. Disconnect battery ground cable.

2. Remove water pump pulley shield.

3. Disconnect fuel charging wiring from Throttle Position (TP) sensor.

4. Remove two TP sensor retaining screws.

5. Remove TP sensor.

INSTALLATION

1. Install TP sensor. Ensure that rotary tangs on sensor are in proper alignment.

CAUTION: Slide rotary tangs into position over throttle shaft blade, then rotate TP sensor clockwise to installed position only. Failure to install the TP sensor in this manner may result in possible damage to the TP sensor or excessive idle speeds.

2. Secure TP sensor to throttle body with two retaining screws. Tighten to 2.8-3.8 Nm (25-34 in lb).

NOTE: This TP sensor is not adjustable.

3. Connect fuel charging wiring to TP sensor.

4. Install water pump pulley shield. Tighten retaining screws securely.

5. Connect battery ground cable.

pro multis · About Operation CHARM