Rear

Wheel Speed Sensors, Rear (Part 1 Of 2):

Wheel Speed Sensors, Rear (Part 2 Of 2):

REMOVAL
1. Raise and support vehicle.
2. Disconnect rear brake anti-lock sensor from the mating body connector located under the vehicle in the center on No.4 crossmember as shown.
3. Disconnect routing clips from rear suspension arm and bushing and No.4 crossmember torque box.
4. Remove retaining bolt and rear brake anti-lock sensor.

INSTALLATION
1. Insert rear brake anti-lock sensor into hole in rear disc brake adapter on sedan, and into hole in rear wheel spindle on station wagon.
2. Install retaining bolt. Tighten to 7.6-10.4 Nm (68-92 inch lbs.).
3. Install sensor routing clips to rear suspension arm and bushing and No.4 crossmember torque box.
3. Connect rear brake anti-lock sensor to mating body connector.
4. Lower vehicle.