Front Fender: Service and Repair

FENDER

Five Hundred, Montego (Part 1):

Five Hundred, Montego (Part 2):

Exploded View

Removal and Installation
1. Remove the radiator grille.
2. Remove the front bumper cover.
3. Remove the front wheel and tire assembly.
4. Remove the fender splash shield.

5. NOTE: If shims are present during removal, be sure to reinstall shims and check fender alignment.

Remove the 2 lower fender mounting bolts located at the lower rear of the fender.

- To install, tighten to 9 Nm (80 lb-in).

6. Remove the 2 fender bracket-to-fender bolts.
- Enter through the wheelhouse opening and reach around the fender bracket to gain access to the fender bracket-to-fender bolts.
- To install, tighten to 9 Nm (80 lb-in).






7. Remove the fender mounting bolt located at the rear of the wheelhouse opening.
- To install, tighten to 9 Nm (80 lb-in).

8. Remove the fender upper mounting bolts.
- To install, tighten to 12 Nm (9 lb-ft).

9. Remove the fender.
10. To install, reverse the removal procedure.