Rear

Adjusting Rear Axle (With KDS)
Special Tools Required:
^ 32 4 200

If camber is not within specification.
Refer to Troubleshooting on the rear axle (alignment check).Troubleshooting at Rear Axle (Checking Axle Geometry)

Caution:
If unable to bring toe-in within specified values.
Refer to Troubleshooting on the rear axle (alignment check).Troubleshooting at Rear Axle (Checking Axle Geometry)





Adjusting toe in:
Release screws (1) and (2) approximately 1 1/2 turns at bearing pedestal.
Attach special tool 32 4 200 to screw (2). Turn special tool and adjust toe-in to specified value.

Install hint:


Compliance housing to body
M12 1.5 x 66 bolt 100 Nm