Transmission Speed Sensor: Service and Repair

Replacing Pulse Generator (Output Speed)

Note: Read out fault of EMS/DME control module, check stored fault memory, rectify faults, clear fault memory.

Turn off ignition.

Remove battery box.





Disconnect pulse generator connector (1).

Remove connector from bracket (2).

Remove pulse generator retaining bolt (3).

Remove pulse generator.

Lubricate seal (4) prior to installing new pulse generator.
Speed sensor to gearbox
M6 x 16 9 Nm

Note: Read out fault of EMS/DME control module, check stored fault memory, rectify faults, clear fault memory.