Ambient Light Sensor: Service and Repair

61 35 177 Removing and installing (replacing) rain/light sensor







IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD protection).







Press on end caps (1) and at same time press them apart; this releases clip connection of both caps (1).







Twist inside mirror (1) at an angle towards front and right/top.
Swivel left end cap (2) off ball neck in direction of arrow; this detaches the engagement clip (3) from the metal foot.







Installation note:
Clips (1) and retaining hooks (2) of end caps (3) must not be damaged, replace if necessary.







Pull out locks (1) in direction of arrow and remove rain/light sensor (2).
Disconnect plug connection (3).

Installation note:
Do not damage optical element covered by rain/light sensor (2).
If necessary, initialize rain/light sensor (2).