Neutral Safety Switch: Adjustments

Fig. 3 Aligning Lever & Switch Holes:

Fig. 4 Removing Slack From Control Cable:

1. Place selector lever in ``N'' position.
2. Place manual control lever in ``N'' position.
3. Rotate switch body so that manual control lever and switch body holes are aligned, Fig. 3.
4. Tighten inhibitor switch mounting bolts to specifications. Ensure not to drop switch body.
5. Loosen transaxle control cable nut and lightly pull end of cable as shown in Fig. 4.
6. Tighten nut to specifications.
7. Ensure that selector lever is in ``N'' position.
8. Ensure selector lever operates on transaxle side in range which corresponds to each position of selector lever.