Ignition Timing: Adjustments

ADJUSTMENT CONDITIONS:
Coolant temperature, 170°F-205°F.
All accessories, Off.
Transmission, N (Neutral).
Parking Brake, ON.



1. Connect timing light.

Ignition Timing Adjustment Connector Location:

2. With the engine stopped, connect a lead wire, between the terminal for ignition timing adjustment (located in the engine compartment) and ground.
3. Start and run the engine at curb idle speed.
Standard value
Curb idle speed....700 ± 100 rpm





4. Check base ignition timing and adjust if necessary.
Standard value
Base Timing....5° ± 2°BTDC

5. If the timing is incorrect, loosen the distributor's holding nut, and then turn the distributor until the timing is correct.
NOTE: The ignition timing will be advanced if the distributor is turned to the left and retarded if it is turned to the right.

6. After adjustment, securely tighten holding nut.
CAUTION: Be careful, when tightening the nut, that the distributor does not move.

7. Stop the engine.
8. Disconnect the lead wire connected at step 2.
9. Start and run the engine at curb idle speed.
10. Check to be sure that the idle ignition timing is correct.
Standard value
Idle Timing....10°BTDC