Transmission Position Sensor/Switch: Adjustments

1. Place selector lever in "N" (Neutral) position.





2. Place manual control lever in "N" (Neutral) position.
3. To adjust, rotate the switch body so that the manual control lever 5 mm (.2 in.) hole and the switch body 5 mm (.2 in.) hole are aligned.
4. Tighten the mounting bolts of the park/neutral position switch body to the specified torque. At this time, take care to prevent dropping the switch body.

Specified torque: 10 - 12 Nm (7 - 9 ft.lbs.)





5. Loosen the nut shown in the figure, and lightly pull the end of the transaxle control cable in the "F" direction by hand.
6. Tighten the nut to the specified torque.

Specified torque: 10 - 14 Nm (7 - 10 ft.lbs.)

7. Check that the selector lever is in "N" position.
8. Check that it securely operates and functions on the transaxle side in the range which corresponds to each position of the selector lever.