Round Waterproof Connector

Foreword
A loose connector should be rectified by removing female terminal from connector housing and raising its lance to establish a more secure engagement.

Round Waterproof Connector:

1. Remove waterproof cap by using a screwdriver.

Round Waterproof Connector:

2. Insert tip of screwdriver [1.4 mm (0.06 in) or 2.0 mm (0.08 in) width] into connector in a manner as shown in the figure. Raise housing lance slightly with it and pull out harness.
3. Insert screwdriver through a hole provided on terminal and raise contact point of male terminal