Toe-In

Fig. 3 Toe Setting:

As viewed from above, wheels must be set so distances A and B, Fig. 3, measured at wheel rims and at axle height, are different at a given value. If distance A is smaller than distance B, setting is known as toe-in. If distance A is greater than distance
B, setting is known as toe-out. Toe setting is given in inches and refers to difference between A and B. If distances A and B are same, toe setting is 0.
Rear toe-in is preset to specification and cannot be adjusted. If rear toe-in is out of specification, bent or damaged components must be replaced.