Component Inspection

MFI RELAY (ASD RELAY) AND FUEL PUMP RELAY CHECK
1. Remove the relay.




2. Check that there is continuity between (4) and (6) terminals.
Standard value: 35-75 Ohms







3. Use jumper leads to connect relay terminal No 6 to the battery (+) terminal and terminal No 4 to the battery (-) terminal.
Check the continuity between relay terminal No 2-8 while connecting and disconnecting the jumper lead at the battery (-) terminal.
4. If there is a defect replace the MFI (ASD) relay or fuel pump relay.